09/12/2015 admin

A.O.S.C.-Mic

We are working on a new project called A.O.S.C. – agents of synchronicity. More about the project soon. But for the start here is the description of the building process of a microphone for that project.

We need a simple mono microphone for long time outdoor usage at a fixed place. We decided to use the Primo EM172-Z1 electret capsule because it is not too expensive and the sound quality is quit good. We bought it directly from Primo in Germany.

Primo EM172-Z1

Using some heat shrink tube,

20151208_114829

a piece of a pipe for electrical installations from a hardware store and some Sugru to fix the capsule inside:

20151208_115340

A 3d printed ring and rubber hair bands as shock mount. For wind protection we have attached a piece of foam and a Rode fur for Lavalier mics onto the capsule

AoscMic03

Photo: blackhole-factory

The house for the mic is a filter of a pump for a garden pond from the hardware store which is then covered by nylon socks..

AoscMic04

Photo: blackhole-factory


AoscMic05

Photo: blackhole-factory

The RainProtector

AoscMic06

Photo: blackhole-factory

Ready to go outside:

A.O.S.C.

Photo: blackhole-factory

By continuing to use the site, you agree to the use of cookies. more information

The cookie settings on this website are set to "allow cookies" to give you the best browsing experience possible. If you continue to use this website without changing your cookie settings or you click "Accept" below then you are consenting to this.

Close